OPERATIONAL INSTRUCTIONS

WIFI

ID: Evereste Experiences

No password needed.

Fireplace

Our home has 1 working fireplace with ceramic logs. It can be used between October and May. It is turned off during the summer. No need for any wood logs. Instructions for use:

  • The switch on the front of the logs should be on Auto. 

  • Turn timer on the wall to the right of the fireplace and the flame should start. 

  • Fireplace is on a timer and will automatically shut off after the set time is completed.

Grill

There is an outdoor propane grill available for your use. There is an outdoor gas grill available for your use. There’s a red valve timer you must turn on before turning on the grill. The timer will automatically shut off after the time chosen and the grill will turn off.

Sauna

NOTE: The 1 hour timer includes the time it takes for the sauna to heat (30 - 60 minutes). If it is necessary, turn the timer dial to 1 hour position again when you go into the sauna.

The sauna heater has two operation dials on the lower front of the heater:

The thermostat on the left.

The timer on the right.

The thermostat controls the temperature of the sauna. Always turn the thermostat up away from the minimum position. The heater does not heat if the thermostat is at the minimum position.

The timer dial has large numbers (0 and 1) and small numbers (1 to 8). The large numbers tell the heating time as follows:

0 - The sauna heater is switched off

1 - The sauna is on for 1 hour and switches off when the dial goes back to 0

The small numbers tell the delay in hours after which the sauna heater switches on and stays on for 1 hour.

When you want to switch on the sauna heater immediately, do the steps that follow.

  1. Turn the thermostat dial to the level of heating that you want. We recommend that you start with the maximum level. The timer dial controls the sauna heater only when the thermostat dial is turned up to a suitable heating level.

  2. Turn the timer dial past the large number 1 to the small numbers. Then turn the dial back to the large number 1 until you hear a "click". The heater will now operate for 1 hour.

  3. Let the sauna heat for 30 to 60 minutes. If the sauna is too hot, adjust the thermostat until the sauna has the temperature that you want.

4. Repeat the step 2 if you want to use the sauna for a longer time.

5. After the timer reaches 0 and you have finished bathing, turn the thermostat dial to the minimum and make sure that the heater is switched off and stopped heating.